2 screw driver (Philips can be used if you're careful) 1mm flat head screw driver for VCO adjustment.RF signal generator with necessary to BNC connector.Power cable from your supply to 4 mm ring terminals (or the original power cable).Vertex Standard VPL-1 serial adapter cable or equivalent (see below).Windows XP to Windows 10 PC with a spare USB port.The following software, documentation and tooling is required to perform this modification: (Optional) Perform full adjustment procedure.Use the Factory Mode to change the HW type.The following steps are required to convert a VHF C version: I found that all our units were capable of operation around 145 MHz without component changes but for lower frequencies this will probably not work. There are genuine BOM differences between the two versions this includes VCO and filter part value changes. These repeaters were used by public services in the 160-170 MHz range, and are now "obsolete" due to the nationwide switch to TETRA. A number of these repeaters were available in the VHF C variant which does not cover the 145 MHz band. This process was worked out for LA1N, Narviks ham radio group in Norway.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |